DeWalt SS200 Manuál s instrukcemi

INSTRUCTION MANUAL16" Scroll Saw(Model SS200)PART NO. 905591 - 05-31-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 15To learn more about DELT

10TILTING THE TABLEThe table (A) Fig. 20, on your scroll saw can be tilted upto 45 degrees to the left for bevel cutting operations.1. Turn the table

11ADJUSTINGHOLDDOWNThe bottom of the holddown (A) Fig. 24, should beadjusted so it contacts the top surface of the work beingcut by loosening lock han

12MAINTENANCELUBRICATIONPerform maintenance below after each 20 hours of use.1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove the four screws (A) Fig

13CHOICE OF BLADESYour scroll saw will accept a wide variety of 5" flat end blades. Consider the following as a general guideline forselecting a

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORSCROLL SAWSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.SAVE THESE INSTRUCTIONS. Refer to

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug an

6ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERS

76. Re-attach blade to upper blade holder. (See thesection “CHANGING BLADES”, begin with instruction#6).7. Assemble table insert (C) Fig. 9, in table

8WRENCH AND BLADESTORAGEA convenient wrench and blade holder (A) Fig. 13, issupplied on the left side of the rear casting, which allowsyou to store t

96. Insert long end (A) Fig. 16, of quickset bladechanging wrench into hole (G) in lower blade holder. Thiswill help align wrench (C) with blade holde