DeWalt DW717-XE Manuál s instrukcemi

DW717-XE 254 mm (10") DOUBLE BEVEL SLIDING COMPOUND MITER SAWINSTRUCTION MANUALQuestions? See us on the World Wide Web at www.dewalt.com

88When cutting anything larger than 111.8 mm (4.4") [76.2 mm (3") 45º miter] use an out-down-back motion with the rail lock knob loosened. P

99TO INSTALL CLAMP 1. Insert it into the hole behind the fence. The clamp should be facing toward the back of the miter saw. The groove on the clam

1010BEVEL SETTING TYPE OF CUT33.85° LeftLEFT SIDE, INSIDE CORNER: 1. Top of molding against fence 2. Miter table set right 31.62° 3. Save left end

1111CUTTING LARGE MATERIALOccasionally you will encounter a piece of wood a little too large to fit beneath the blade guard. If this occurs, simply pl

1212MAINTENANCEDO NOT use lubricants or cleaners (particularly spray or aerosol) in the vicinity of the plastic guard. The polycarbonate material used

1313101010202020303030404040505050606060707070808080TABLE 1: COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE AND THE NARROW EDGE A

DEWALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138 Australia (03 8720 5100) • 5 Te Apunga Place, Mt Wellington, New Zealand (09 259

TABLE OF CONTENTSDOUBLE INSULATION INSTRUCTIONS...

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

22 • STABILITY. Make sure the miter saw is placed on a secure supporting surface and does not slip or move during use. If the mobility kit is install

33Electrical ConnectionThe electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the

4Unpacking Your SawCheck the contents of your miter saw carton to make sure that you have received all parts. In addition to this instruction manual,

5 4. Depress the spindle lock button (C) while carefully rotating the saw blade by hand until the lock engages. 5. Keeping the button depressed, use

66AdjustmentsWARNING: To reduce the risk of serious personal injury, turn off the tool and disconnect it from the power source before attempting to mo

7when the bevel lock handle is tightened. To adjust the bevel lock handle, remove the screw in the center of the handle. Carefully pry off the handle