DeWalt DCS381-XE Manuál s instrukcemi

DCS380-XE, DCS381-XE18 V CORDLESS RECIPROCATING SAWSINSTRUCTION MANUAL

8OPERATIONWARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or

9WARNING: Cut hazard. Blade breakage may occur if the blade does not extend past the shoe and the workpiece during the cut (Fig. 5). Increased risk of

10Cutting with Blade in Horizontal Position (DCS380-XE only) (Fig. 8)Your DCS380-XE is equipped with a horizontal blade clamp. Installing a blade in t

11POCKET/PLUNGE CUTTING – WOOD ONLY (FIG. 12)The initial step in pocket cutting is to measure the surface area to be cut and mark clearly with a penci

12CleaningWARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear A

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia (MAR11) Part No. N111154 DCS

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch

3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in

4 • Charge the battery packs only in designated DEWALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the t

5 • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.WARNING: Burn

6 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or

7 c. Move the charger and battery pack to a location where the surrounding air temperature is approximately 18° – 24°C (65°F and 75°F); d. If