DeWalt DCS355-XE Manuál s instrukcemi

DCS355-XE18V BRUSHLESS CORDLESS MULTI TOOLINSTRUCTION MANUAL

8Installing/Removing Accessories (Fig. 3–5)TOOL-FREE ACCESSORY CLAMPThe DCS355 features a quick change accessory system. This allows for faster access

9INSTALLING/REMOVING SANDING SHEETS (FIG. 6)A diamond shaped platen uses a hook and loop adhesion system to attach the sanding sheets. The platen allo

10 2. Adjust the length of the guide by pulling out or pushing inward to achieve the desired length as shown in Figure 12. 3. Secure the guide in pl

11AFIG. 16Variable Speed Trigger (Fig. 16)WARNING: Ensure switch is fully OFF before installing the battery pack. 1. Install the battery pack. 2. To

MAINTENANCEWARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack before making any adjustments or

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCEThe term “power tool” in the warnings refers to your mains-operated (corded) power tool or bat

3d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the

4min ...minutes or AC ...alternating currentor DC ...direct current or AC/DC ...alternating or ...Class

5 NOTE: Do not store the battery packs in a tool with the trigger switch locked on. Never tape the trigger switch in the ON position.WARNING: Fire

6 • Do not place any object on top of the charger or place the charger on a soft surface that might block the ventilation slots and result in excessiv

7NOTE: This could also mean a problem with a charger.PROBLEM POWERLINESome chargers have a problem powerline indicator. When the charger is used with