DeWalt DCS310-XE Manuál s instrukcemi

DCS310-XE 10.8V CORDLESS PIVOT RECIPROCATING SAWINSTRUCTION MANUAL

8OPERATIONWARNING: To reduce the risk of serious personal injury, lock the trigger switch and disconnect battery pack before making any adjustments or

9Proper Hand Position (Fig. 4)WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown. WARNING: To reduce the

10Different blade lengths are available. Use the appropriate blade for the application. The blade should be longer than 89 mm (3-1/2") and should

11jumping or vibrating and minimize blade breakage. Any cuts which put pressure on the blade such as angle or scroll cuts increase potential for vibra

12the workpiece during the cut. Use a longer blade if needed. Whenever possible, the saw shoe must be held firmly against the material being cut. This

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.com.nz

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool.SAVE THESE INSTRUCT

3operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.f) Keep cutting tools sh

4 • The label on your tool may include the following symbols. The symbols and their definitions are as follows:V ... volts A ...

5WARNING: Fire hazard. Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger.

6 • Do not operate charger with damaged cord or plug. • Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged i

7LEAVING THE BATTERY PACK IN THE CHARGERThe charger and battery pack can be left connected with the charge indicator showing Pack Charged.WEAK BATTERY