DeWalt DCG422-XE Manuál s instrukcemi

DCG412-XE, DCG422-XE 18 V CORDLESS CUT-OFF TOOLINSTRUCTION MANUAL

8Chargers Your tool uses a DEWALT charger. Be sure to read all safety instructions before using your charger. Consult the chart at the end of this man

9Charge Indicators This charger is designed to detect certain problems that can arise. Problems are indicated by the red light flashing at a fast rate

10Storage Recommendations 1. The best storage place is one that is cool and dry, away from direct sunlight and excess heat or cold. 2. For long stor

11AccessoriesIt is important to choose the correct guards, backing pads and flanges to use with grinder accessories. Refer to pages 12 and 13 for info

12Type 27 guard*125 mm (5") Grinding Wheelsunthreaded backing flangethreaded clamp nutType 27 hubbed wheelType 27 guard*Type 27 depressed center

13125 mm (5") Sanding Flap Discshubbed sanding flap discunthreaded backing flangenon-hubbed sanding flap discthreaded clamp nutrubber backing pad

14OPERATIONWARNING: To reduce the risk of serious personal injury, turn tool off and remove the battery pack before making any adjustments or removing

15SPINDLE LOCK BUTTON (FIG. 2)The spindle lock button (C) is provided to prevent the spindle from rotating when installing or removing wheels. Operate

16 5. To remove the wheel, depress the spindle lock button and loosen the threaded clamp nut with a wrench.NOTE: If the wheel spins after the clamp n

17WARNING: Proper guard must be reinstalled for grinding wheel, cutting wheel, sanding flap disc, wire brush or wire wheel applications after sanding

18ENVIRONMENTAL SAFETY 1. Paint should be removed in such a manner as to minimize the amount of dust generated. 2. Areas where paint removal is occu

19WARNING: A closed, two-sided cutting wheel guard is included with this tool and is re quired when using cutting wheels. Fail ure to use proper flang

MAINTENANCEWARNING: To reduce the risk of serious personal injury, turn tool off and remove the battery pack before making any adjustments or removing

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE WARNING! Read all safety warnings and all instructions Failure to follow the warnings and ins

3c) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or sto

4k) Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power too

5a) Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces. Always use auxiliary handle, if pro

6Safety Warnings Specific for Polishing Operationsa) Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely.

7 • Do not charge or use the battery pack in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing