DeWalt DCD780-XE Manuál s instrukcemi

DCD780-XE 18 V CORDLESS COMPACT 13 mm (1/2") DRILL/DRIVERDCD785-XE 18 V CORDLESS COMPACT 13 mm (1/2") DRILL/DRIVER/HAMMERDRILLINSTRUCTION MA

8NOTE: Do not change gears when the tool is running. Always allow the drill to come to a complete stop before changing gears. If you are having troubl

9 2. Grasp the black sleeve of the chuck with one hand and use the other hand to secure the tool. Rotate the sleeve counterclockwise far enough to ac

10WARNING: Drill may stall if overloaded causing a sudden twist. Always expect the stall. Grip the drill firmly to control the twisting action and avo

11LubricationYour power tool requires no additional lubrication.CleaningWARNING: Blow dirt and dust out of all air vents with clean, dry air at least

Stanley Black & Decker701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia (MAR11) Part No. N106245 DCD

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch

3 • Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised DEWALT Service Centre in

4 • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and battery pack in locations where the temperature may reach

5 • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.WARNING: Burn

6 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or

7 b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights; c. Move the charger and ba