DeWalt DCD720-XE Manuál s instrukcemi

DCD720-XE CORDLESS RIGHT ANGLE DRILL/DRIVERINSTRUCTION MANUAL

8INTENDED USEThis drill is designed for professional drilling and screwdriving applications. DO NOT use under wet conditions or in presence of flammab

9When changing the position of the control button, be sure the paddle is released. NOTE: The first time the tool is run after changing the direction o

10Installing and Removing the Battery Pack (Fig. 3)NOTE: For best results, make sure your battery pack is fully charged. IJFIG. 3To install the batter

11 2. Use sharp drill bits only. 3. Always apply pressure in a straight line with the bit. Use enough pressure to keep drill biting, but do not pus

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2safety instructions before attempting to operate this product. Keep these instructions in a safe place. WARNING: To reduce the risk of injury, user m

3b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and mu

4exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals. WARNIN

5READ ALL INSTRUCTIONS • Do not charge or use the battery pack in explosive atmospheres, such as in the presence of flammable liquids, gases or dust

6 • Do not expose the charger to rain or snow. • Pull by the plug rather than the cord when disconnecting the charger. This will reduce the risk of da

7Charge Indicators This charger is designed to detect certain problems that can arise. Problems are indicated by the red light flashing at a fast rate