DC927-XEHEAVY-DUTY 13 MM (1/2") CORDLESS HAMMERDRILLINSTRUCTION MANUAL
8The center position of the control button locks the tool in the OFF position. When changing the position of the control button, be sure the trigger i
9 2. Rotate the mode control collar (C) so the screw symbol is aligned with the arrow. 3. Set the torque adjustment collar (D) to the appropriate
10Installing and Removing the Battery Pack (Fig. 8, 9)NOTE: Make sure your battery pack is fully charged. CAUTION: Make certain the lock-off button (B
11adjustment collar (D) to the desired setting. Make a few practice runs in scrap or unseen areas to determine the proper position of the clutch colla
12NOTE: Three Year Warranty is not applicable to items deemed as consumables. Radial arm saws are covered by a one (1) year warranty only. DEWALT Rese
DEWALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138 Australia (03 8720 5100) • 5 Te Apunga Place, Mt Wellington, New Zealand (09 259
1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ).SAFETY INSTRUCTIONS FOR POWE
2c. Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or p
3 • Young children and the infirm. This appliance is not intended for use by young children or infirm persons without supervision. Young children shou
4 • Charge the battery packs only in DEWALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and bat
5b. and the battery liquid gets into your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. (Medica
6 • When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of
7Indicator Light OperationCharge Indicators Some chargers are designed to detect certain problems that can arise with battery packs. Problems are indi
Komentáře k této Příručce