DeWalt 36-085 Manuál s instrukcemi

INSTRUCTION MANUAL10" Dual Bevel CompoundPower Miter Saw(Model 36-085)PART NO. 901694 - 08-31-01Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 1

10POINTER AND SCALEA pointer (B) Fig. 19 indicates the actual angle of cut. Eachline on the scale (C) represents 1 degree. When the pointeris rotated

11Fig. 22 Fig. 23REAR SUPPORT/CARRYING HANDLEA rear stabilizer bar (A) Fig. 22, is provided to prevent the miter saw from tipping to the rear when the

12Fig. 27Fig. 28ADJUSTING THE FENCE90 DEGREES TO THE BLADEThe fence (A) Fig. 27 should be adjusted so that it is 90degrees to the blade. To adjust: 1.

132. Set the saw blade on the “0” degree positive miter stop.3. Use one end of a square (A) Fig. 29 on the table and the other end against the blade.

TYPICAL OPERATIONS AND HELPFUL HINTS1. Before cutting, be certain that the cutting arm andtable are at their correct settings and are firmly locked

15Fig. 41Fig. 42CUTTING CROWN MOLDINGOne of the many features of a compound miter saw is the ease of cutting crown molding. The following is an exampl

2. Remove the screw (A) Fig. 45, and rotate the cover(B) to the rear (Fig. 46).3. Depress the arbor lock (A) Fig. 47, to keep the bladefrom turning.4.

17Fig. 49Fig. 50Fig. 51BRUSH INSPECTIONAND REPLACEMENTCAUTION: BEFORE INSPECTING THE BRUSHES,DISCONNECT THE TOOL FROM THE POWERSOURCE.Brush life varie

18Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

3636363636The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WOR

GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, certainhazards are i

33ADDITIONAL SAFETY RULES FORMITER SAWS1. USE ONLY CROSS-CUTTING SAW BLADES. Whenusing carbide tipped blades, be certain that they have a neg-ative h

4CONNECTING TOOL TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12

5Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug a

6IMPORTANT: DO NOT LIFT THE MITER SAW BY THESWITCH HANDLE. THIS ACTION CAN CAUSE MIS-ALIGNMENT. ALWAYS LIFT THE MACHINE BY THEBASE OR CARRYING HANDLE.

7Fig. 8Fig. 9Fig. 10ABBCDEATTACHING STOCK STOPAND TABLE EXTENSIONS1. Decide on which side of the saw table you want thestock stop (A) Fig. 8, and atta

8OPERATING CONTROLS AND ADJUSTMENTSTABLE HAZARD AREAWARNING: THE AREA INSIDE THE TWO REDLINES (A) FIG. 15 ON THE TABLE IS DESIGNATEDAS A HAZARD ZONE.

9Fig. 17Fig. 16STARTING AND STOPPING THE MACHINETo start the machine, squeeze the trigger (A) Fig. 16. To stop the machine, release thetrigger.This mi