DeWalt DCF895-XE Manuál s instrukcemi

DCF895-XE6.35 mm (1/4") 18 V BRUSHLESS CORDLESS IMPACT DRIVERINSTRUCTION MANUAL

8Belt Hook and Bit Clip (Fig. 2, 3) WARNING: To reduce the risk of serious personalFIG. 3LI injury, place the forward/reverse button in the lock-off p

9FEFIG. 4Fuel Gauge Battery Packs (Fig. 2)Some DEWALT battery packs include a fuel gauge which consists of three green LED lights that indicate the le

10FIG. 6DFIG. 7CDUsageCAUTION: Ensure fastener and/or system will withstand the level of torque generated by the tool. Excessive torque may cause brea

11Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating an

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(MAR

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

2GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings and all instructions Failure to follow the warnings and instructions may result

3d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the

4 • The label on your tool may include the following symbols. The symbols and their definitions are as follows:V ... volts A ...

5 NOTE: Do not store the battery packs in a tool with the trigger switch locked on. Never tape the trigger switch in the ON position.WARNING: Fire

6 • Do not place any object on top of the charger or place the charger on a soft surface that might block the ventilation slots and result in excessiv

7NOTE: This could also mean a problem with a charger.PROBLEM POWER LINESome chargers have a Problem Powerline indicator. When the charger is used with