DeWalt DCD995-XE Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro Rázové utahováky DeWalt DCD995-XE. DeWalt DCD995-XE Instruction manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
DCD995-XE
BRUSHLESS CORDLESS 13 mm (1/2") DRILL/DRIVER/HAMMERDRILL
INSTRUCTION MANUAL
Zobrazit stránku 0
1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1 - INSTRUCTION MANUAL

DCD995-XE BRUSHLESS CORDLESS 13 mm (1/2") DRILL/DRIVER/HAMMERDRILLINSTRUCTION MANUAL

Strany 2

8FIG. 2FDEABCIJ KLGHASSEMBLY AND ADJUSTMENTSWARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack

Strany 3 - Technical Data

9Side Handle (Fig. 2)WARNING: To reduce the risk of personal injury, ALWAYS operate the tool with the side handle properly installed. Failure to do so

Strany 4

10Your tool features a keyless chuck with one rotating sleeve for one-handed operation of the chuck. To insert a drill bit or other accessory, follow

Strany 5 - Extension Cords

11FUEL GAUGE BATTERY PACKS (FIG. 10) MFIG. 10Some DEWALT battery packs include a fuel gauge which consists of three green LED lights that indicate the

Strany 6

Hammerdrill Operation (Fig. 5) 1. Select the desired speed/torque range using the gear shifter to match the speed and torque to the planned operation

Strany 8 - Indicator Light Operation

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz(

Strany 10 - FUTURE REFERENCE

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

Strany 11 - FIG. 3 FIG. 4 FIG. 5

2 An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running bu

Strany 12 - OPERATION

3e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.f) Dress

Strany 13 - Drill Operation (Fig. 3)

4• crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber.Your risk from t

Strany 14 - EWALT, have not been

5SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCEImportant Safety Instructions for All Battery PacksWhen ordering replacement battery packs, be

Strany 15

6NOTICE: Under certain conditions, with the charger plugged into the power supply, the charger can be shorted by foreign material. Foreign materials o

Strany 16 - 230 Volts 12 Volts

7Charge Indicators This charger is designed to detect certain problems that can arise. Problems are indicated by the red light flashing at a fast rate

Komentáře k této Příručce

Žádné komentáře