DeWalt DCD936 Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro Rázové utahováky DeWalt DCD936. DeWalt DCD936 Instruction manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - INSTRUCTION MANUAL

DCD936-XE, DCD985-XE13 mm (1/2") CORDLESS DRILL/DRIVER/HAMMERDRILLINSTRUCTION MANUAL

Strany 2

8COMPONENTS (FIG. 2)WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. A. Trigger switch H. Side handle

Strany 3 - Technical Data

9INTENDED USEThese drills/drivers/hammerdrills are designed for professional drilling, percussion drilling and screwdriving applications. DO NOT use u

Strany 4

10SCREWDRIVING HAMMERDRILLINGDRILLINGEFGEFGFIG. 5FIG. 4FIG. 3HAMMERDRILLING (FIG. 5)CAUTION: When the mode collar is in the drill/hammerdrill mode, th

Strany 5 - Electrical Safety

11Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the tool for maximum tightness. To release the accessory, repeat Ste

Strany 6 - Extension Cords

12 3. Always apply pressure in a straight line with the bit. Use enough pressure to keep the drill bit biting, but do not push hard enough to stall t

Strany 7 - READ ALL INSTRUCTIONS

13CHARGER CLEANING INSTRUCTIONSWARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from t

Strany 8 - Charging Procedure (Fig. 1)

Stanley Black & Decker82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ)www.dewalt.com.au • www.dewalt.co.nz

Strany 10 - FUTURE REFERENCE

1Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to

Strany 11

2 An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running bu

Strany 12

3e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.f) Dress

Strany 13 - Drilling (Fig. 3)

4 • Air vents often cover moving parts and should be avoided. Loose clothes, jewellery or long hair can be caught in moving parts.WARNING: We recomm

Strany 14 - MAINTENANCE

5 • The label on your tool may include the following symbols. The symbols and their definitions are as follows:V ... volts A ...

Strany 15 - ACCESSORIES

6 • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.WARNING: Burn ha

Strany 16

7FIG. 1IIndicator Light OperationPACK CHARGINGPACK CHARGEDxHOT/COLD DELAYPROBLEM PACK OR CHARGERPROBLEM POWERLINECharge Indicators This charger is des

Komentáře k této Příručce

Žádné komentáře