DeWalt DW087-XE Manuál s instrukcemi

DW086-XE, DW087-XE LASERCHALKLINE™ LASER LINE GENERATORSINSTRUCTION MANUAL

10 2. Turn on the laser’s vertical beam and position the unit at one end of the line, facing the line. 3. Adjust the unit so its beam is aligned and

11This warranty does not apply to • Accessories • Damage caused where repairs have been made or attempted by others. • Damage due to misuse, neglect

DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia(SEP06) Form No. 647

3IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 526 2556 (NZ).SAFETY INSTRUCTIONS FOR POWE

4 • Position the laser securely on a level surface. Damage to the laser or serious injury could result if the laser falls.WARNING: Some dust created

5INTRODUCTIONThe DW086-XE and DW087-XE lasers are self-leveling laser tools that can be used inside and outside for horizontal (level) and vertical (p

6continue to drain, but the beam(s) will quickly dim. After fresh batteries are installed and the laser is turned on again, the laser beam(s) will ret

7OUT OF TILT RANGE INDICATOR (FIG. 3, 4)The DW086-XE and DW087-XE lasers are designed to self-level. If the laser has been tilted so much that it cann

8hole (H), allowing the wall mount to be attached to any surface with a nail or screw. Once the wall mount is secured, its steel plate provides a surf

9 1. Attach the laser to one end of a wall using its pivot bracket. 2. Turn on the laser’s horizontal beam and pivot the laser toward the opposite e