DeWalt DC608-XE Manuál s instrukcemi

DC608-XEDC609-XE (Sequential Fire Action only)18 GAUGE CORDLESS NAILERINSTRUCTION MANUAL

8MINIMUM GAUGE FOR CORD SETSFor Cable length (m): 7.5 15 25 30 45 60Use Cable with minimum rating (Amperes)Tool Amperes 0 - 3.4 7.5 7.5 7.5

9before use. A battery pack may also slowly lose its charge if left in a charger that is not plugged into an appropriate AC source.WEAK BATTERY PACKS:

10 6. Do not freeze or immerse charger in water or any other liquid.WARNING: Shock hazard. Don’t allow any liquid to get inside charger. Electric sho

11Before operating this tool, look at the selector switch to determine the actuation mode. Read all instructions before selecting actuation mode. WARN

12 5. Check for smooth and proper operation of contact trip and pusher assemblies. Do not use tool if either assembly is not functioning properly. NE

13Headlights (Fig. 10) CDFIG. 10There is a headlight (D) located on each side of the nailer. Headlights turn on upon battery insertion, activation of

14The DEWALT cordless nailers include an integrated suspension hook (I) and can be attached to either side of the tool to accommodate left- or right-h

15Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating an

16TROUBLESHOOTING GUIDEMANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A DEWA

17Tool operates, but does not drive the fastener fully Low battery charge or damaged battery Charge or replace battery Depth adjustment set too sha

DEWALT Battery and Charger Systems Battery Output Chargers/Charge Time Nominal 240 Volts 12 VoltsX Indicates that the battery pack is not c

1 A. Trigger B. Contact trip lock-off C. Depth adjustment wheel D. Headlights/low battery/jam indicator E. Jam clearing latch F. Contact trip G. M

2IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (AUS) or 09 259 1111 (NZ).SAFETY INSTRUCTIONS FOR POWER

3 • Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be used for appropriate

4FIG. Ethe employer’s responsibility to enforce the use of eye protection equipment by the tool operator and other people in the work area. (Fig. A) •

5FIG. IFIG. JUnwanted fasteners may be driven if the contact trip is allowed to accidentally re-contact the work surface. TO AVOID DOUBLE FIRES:• D

6 • Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and

7NOTE: Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charger. Remove cap before placing battery i