DeWalt DW744 Manuál s instrukcemi

INSTRUCTION MANUALTABLE SAWMODEL DW744 DW744-XE/387486-01 5/1/02 3:43 PM Page 2

6RIP SCALE POINTERNOTE: The rip scale pointer will need to be readjusted whenever a thicker or thinnerblade is installed.On-Off SwitchLift the switch

7feed direction. During kickback, the workpiece could be thrown back at the operator. Itcan also drag the operator’s hand back into the blade if the

8WARNING: Before connecting the table saw to the power source or operating thesaw, always inspect the guard and splitter for proper alignment and cle

9Dust CollectionYour table saw is equipped with a dust shroud and dust collection port. For bestresults, connect a vacuum to the port at the rear of

NOTE: THIS INSTRUCTION MANUAL IS APPLICABLE FOR THE FOLLOWING SUB-CODES: -XEDEWALT INDUSTRIAL TOOL COMPANY

1 2 435 6 DW744-XE/387486-01 5/1/02 3:43 PM Page 3

7 9 12 157A 10 13 168 11 14 171 DW744-XE/387486-01 5/1/02 3:44 PM Page 4

18 21 2419 2220 2325 DW744-XE/387486-01 5/1/02 3:44 PM Page 6

1Safety InstructionsWhen using power tools, always observe the safety regulations applicable in yourcountry to reduce the risk of fire, electric shock

2Description Fig. 2Figure 2 shows all the loose items andhardware packed with the saw.1. Rip fence2. Blade (attached to saw base)3. Arbor wrench and s

3• IF YOU STALL OR JAM the saw blade in the workpiece, turn saw OFF, removethe workpiece from the saw blade, and check to see if the saw blade is par

4SpecificationsTable Size: 19 1/4” (489 mm) x 26 1/2” (673 mm)Mitre Angle: 30º L&RBevel Angle: 0° to 45°LBlade Size: 10” (254 mm)Max. Cut Dept

5blade guard as shown in Fig. 11, ensuring the bolts fit into the slots on the bladeguard. The top of the slots must rest on the bolts. The bottom e